Call Back - NEC UNIVERGE SV9300 DT410 User Manual

2. Press Trunk Queuing – Outgoing
feature key.
You will receive a service set tone.
Trunk Queuing – Outgoing feature is
cancelled.
Outgoing feature key lamp goes off. →
CANCEL
11:00 AM SUN 1 JUN 2014
3. Replace the handset.
Line key lamp goes off. →

CALL BACK

This feature allows a calling party to set an
automatic Call Back when a busy or no answer
condition is encountered. When the busy terminal
becomes idle, the terminal that set the Call Back
will be called.
This feature is set by Soft key or feature key.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
TO SET CALL BACK
This feature is available only for the terminal
that is set by system data setting at initial
installation.
1. The called party extension is busy or
no answer.
You will receive a busy tone.
Line key lamp lights green. →
BUSY
11:00 AM SUN 1 JUN 2014
CB
2. Press Soft key (CB) or Call Back
feature key.
You will receive a service set tone.
SET
11:00 AM SUN 1 JUN 2014
3. Replace the handset.
Wait Call Back.
Line key lamp goes off. →
46
FEATURE OPERATION
201
CW >>>>
201