Call Pickup - Group - NEC UNIVERGE SV9300 DT410 User Manual

TO ANSWER A CALL WITH
HANDSFREE
1. The Call Indicator Lamp flashing.
Line key lamp flashes red. →
2. Press Speaker key.
Speaker key lamp lights red. →
Line key lamp lights green. →
3. Talk toward the mic.
11:00 AM SUN 1 JUN 2014
MIC Mute
When you make a call handsfree, please
note the following items.
• Avoid using in a place where there is a
lot of echo or noise.
• The Microphone is located at the front
of the terminal. It should be no further
away than 50 CM.
• When talking handsfree be aware of the
volume level as to not disturb people
close to you.
• Talk alternately with the other party.
The voice may be interrupted if both
parties talk at the same time.

CALL PICKUP - GROUP

201
41
FEATURE OPERATION
This feature permits a terminal user to answer any
calls directed to other extensions in their preset
pickup group.
This feature is set by system data setting at
initial installation. For details, please contact
the system administrator.
This feature is set by Soft key or feature key.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
1. Ringing terminal in your Call Pickup
- Group.
2. Press Speaker key.
Speaker key lamp lights red. →
Line key lamp lights green. →
11:00 AM SUN 1 JUN 2014
Recall PICK
3. Press Soft key (PICK) or Call Pickup
- Group feature key.
PICK UP
11:00 AM SUN 1 JUN 2014
MIC Mute
4. Start conversation with calling
party.
200
>>>>
201 210