Timed Queuing (Outside Line Only); To Make/Answer A Call During Call In Progress - NEC UNIVERGE SV9300 DT410 User Manual

TIMED QUEUING (OUTSIDE
LINE ONLY)
When a user originates an outgoing trunk call and
the called party is busy or does not answer, the
caller can set the Timed Queuing. When this
feature is set, the trunk seizure is repeated and the
number is dialed again after a predetermined time
interval.
The feature key is set by system data setting
at initial installation. For details, please
contact the system administrator.
1. Press Speaker key.
You will receive a dial tone.
Speaker key lamp lights red. →
11:00 AM SUN 1 JUN 2014
Recall PICK
2. Dial Outside Line access code.
11:00 AM SUN 1 JUN 2014
Recall PICK
3. Dial desired number.
You will receive a busy tone or a ring no
answer from distant end.
BUSY
11:00 AM SUN 1 JUN 2014
CB
4. Press Call Back feature key.
Line key lamp is flashing green. →
5. Leave speaker on.
The desired number is automatically redialed.
6. Start conversation with called party.
Busy tone is sent to the calling party when
the call is made to the extension that is in
Timed Queue mode.
200
>>>>
8
>>>>
81XXXXXXXXXX
TO MAKE/ANSWER A CALL
DURING CALL IN
PROGRESS
This feature permits a user to hold a call in
progress by pressing the Call Hold feature key.
This line can then be used for originating another
call or answering another incoming call. After
finishing another call and replace the handset, the
original held call rings back.
It is required that the dedicated feature key
other than fixed feature key (Hold) shall be
set by system data setting at initial
installation. For details, please contact the
system administrator.
1. While call in progress,
The Line key lamp lights green. →
2. Press call hold feature key.
Call hold feature key lamp doesn't light. →
The called party will receive a hold tone.
0:00:05
11:00 AM SUN 1 JUN 2014
MIC
3. To make a call to another party or
answer the incoming call.
Replace the handset after finishing a call.
4. The original call rings back.
Call Indicator Lamp flashes red.
Line key lamp flashes red. →
RECALL
11:00 AM SUN 1 JUN 2014
MIC
48
FEATURE OPERATION
26-255XX
Mute
26-255XX
DIR HIST. >>>>