S&R; Call Back; Shift; Feature - NEC D-Term Series E User Manual

S&R (Save and Redial)
This key acts as a one-time-only speed dial. While on a call, you may press the S&R button to
save the number. The LED will light up and your display will indicate "S&R." The number will
remain saved indefinitely. To redial the number, lift your handset or press the Speaker key.
Listen for dial tone, then press the S&R key. The LED light will go off and your phone will begin
dialing automatically.
Note: Once you redial, the number is no longer saved. You may save the number again by
repeating the above steps.

Call Back

When a busy signal is received after dialing a campus number, this feature allows your D-Term
phone to notify you and automatically complete the call when the line is free.
TO ACTIVATE CALL BACK
After receiving a busy signal from an extension, press the Call Back key, and hang up. You will
be able to make and receive other calls in the meantime. When the busy extension becomes
free, your phone will ring and the display will indicate "CALL BACK."
TO CANCEL CALL BACK
To cancel this feature after it has been activated, get a dial tone and press the Call Back key.

Shift

The Shift key allows you to save an additional 16 speed dial keys. For more information on
speed dial keys, see page 8.

Feature

The feature key is used to activate or change features on your phone. You can use the Feature
key to set your speed dials, activate Answer mode, and change several phone settings. Included
below is a list of features you can change using the Feature key. For more information on speed
dial keys, see page 8.
Feature + 1 – Turn the Microphone on/off
Feature + 2 – Adjust handset receiver volume
Feature + 3 – Change ring tone
Feature + 4 – Adjust transmission/receiving volume
Feature + 5 – Activate hands-free operation
Feature + 6 – Deactivate hands-free operation
Feature + 7 – Turns Call Waiting Lamp on/off for incoming call notification (Note: The Call
Waiting Lamp will still light up when you receive a voicemail, even if you have turned the light
off for incoming calls.)
Feature + Answer – Activate/Deactivate Answer mode (see page 11)
10