Section 13: Radio Installation - Hangar 9 Twist 3D .40 Assembly Manual

Section 13: Radio Installation

Required Parts
• Fuselage assembly
• Servo w/hardware (5)
Required Tools and Adhesives
• Drill
• Phillips screwdriver (small)
• Servo extension – 12" (2)
Step 1
Install the recommended servo hardware (grommets
and eyelets) supplied with your radio system onto
five servos (elevator, rudder, throttle, and aileron (2).
Step 2
Temporarily install the rudder servo.
Step 3
Mark the locations for the servo screws using
a felt-tipped pen.
Step 4
Remove the servo and drill the holes for the servo
mounting screws using a 1/16" drill bit.
• Wing assembly
• Drill bit: 1/16"
Hint: Place a drop of thin CA onto each
screw hole to harden the wood around the
hole. Allow the CA to fully cure before
installing the servos.
Step 5
Attach a 12" servo extension onto the rudder
servo. Use your favorite method to secure the
extension to prevent it from coming loose during
flight. Secure the rudder servo using the screws
provided with the servo.
Step 6
Repeat Steps 1 through 5 for the elevator servo.
27