Hangar 9 Twist 3D .40 Assembly Manual page 20

Step 7
Attach the motor to the motor mount plate.
Step 8
Thread an 8-32 nut and #8 washers onto each of
the threaded rods. Slide the motor and mount onto
the rods. Position the motor so the drive washer will
be 4-1/4" forward of the firewall. Secure the plate
using 8-32 lock nuts and #8 washers after making
sure it is parallel to the firewall. Use 5-minute epoxy
to glue the mount plate to the sides of the fuselage.
20
Step 9
Select a propeller appropriate for your motor system.
Install the propeller and spinner as shown.
Step 10
Prepare your ESC for connection to the motor and
motor battery following the instructions provided by
the manufacturer. Remove the covering from the
bottom of the fuselage and secure the ESC as
shown.
Step 11
Mount the battery in the fuselage. It will be
necessary to remove the throttle servo tray to fit
the length of the battery. Make sure the battery
can not shift during flight.