Hangar 9 Twist 3D .40 Assembly Manual page 29

Step 12
Secure the throttle servo using the screws supplied
with the servo.
Step 13
Wrap the receiver and receiver battery in
protective foam to prevent damage that may be
caused by engine vibration.
Section 13: Radio Installation
Step 14
Temporarily mount the receiver and battery into
the fuselage. It may be necessary to relocate the
battery forward or aft to balance the model as
described in the section "Control Throws and Center
of Gravity." Plug in any servo leads or extensions
at this time and connect any extensions necessary
for the aileron servos.
Step 15
Route the antenna out through the tube
in the fuselage.
Step 16
Mount the radio switch in the side of the fuselage
opposite the throttle linkage.
29