Section 10: Fuel Tank Assembly - Hangar 9 Twist 3D .40 Assembly Manual

Section 9: Throttle Pushrod Installation
Step 3
Slide a clevis retainer onto a nylon clevis. Thread a
clevis onto a 14 5 / " wire, a minimum of 10 turns.
8

Section 10: Fuel Tank Assembly

Required Parts
• Clunk (fuel pickup)
• Fuel pickup tubing
• Rubber stopper
• Metal tube (2)
Required Tools and Adhesives
• Hobby knife
• Phillips screwdriver (small)
Note: The stopper provided with the Twist™
has three holes that are not bored completely
through the stopper. The holes are for the
fuel pickup, fill and vent lines. For these
instructions, only two holes will be used: one
for the fuel pickup and one for the fuel vent.
Only open the third hole if you are going to
use a separate fill line.
22
• Metal caps (2)
• Fuel tank
• M3 x 20 screw
Step 4
Attach the clevis to the throttle arm on the
carburetor. Slide the pushrod wire into the pushrod
tube and re-install the engine. Bend the pushrod if
necessary so it moves freely.
Step 1
Locate the fuel tank parts.