Section 14: Linkage Installation - Hangar 9 Twist 3D .40 Assembly Manual

Section 14: Linkage Installation

Required Parts
• Fuselage assembly
• 4 3 / " pushrod wire (2)
8
• 10 5 / " pushrod wire (2)
8
• Nylon wire keeper (5)
• Nylon control horn (4)
• 2-56 x 1/2" screw (12)
Required Tools and Adhesives
• Drill bits: 1/16", 3/32"
• Phillips screwdriver (small)
Step 1
Slide a clevis retainer onto a nylon clevis. Thread a
clevis onto a 10 5 / " wire, a minimum of 10 turns.
8
Step 2
Remove the back plate from a control horn using
side cutters or a sharp hobby knife.
30
• Wing assembly
• Nylon clevis (4)
• Clevis retainer (4)
• Drill
Step 3
Position the control horn on the elevator so the
horn aligns with the hinge line of the elevator.
Mark the position for the mounting holes using
a felt-tipped pen.
Step 4
Drill three 3/32" holes through the elevator at the
locations marked in the previous step.