Section 4: Installing The Ailerons - Hangar 9 Twist 3D .40 Assembly Manual

Section 4: Installing the Ailerons

Required Parts
• Wing
• Aileron (left and right)
Required Tools and Adhesives
• Thin CA
Step 1
Locate 8 of the CA hinges. Place a T-pin in the
center of four of the hinges.
Step 2
Place the hinges in the precut slots in the aileron
(or wing if you prefer). The T-pin will rest against
the edge when installed correctly.
• CA hinge (8)
• T-Pins
Step 3
Slide the aileron and wing together. The gap
between the aileron and wing should be infinitely
small, approximately 1/64".
Hint: Be careful of the T-Pins, as they
can be sharp.
Step 4
Use a ruler to align the end of the aileron to the
wing.
Note: Do not use CA accelerator during the
hinging process. The CA must be allowed to
soak into the hinge to provide the best bond.
Using accelerator will not provide enough
time for this process.
11