Section 15: Canopy Installation - Hangar 9 Twist 3D .40 Assembly Manual

Section 14: Linkage Installation
Step 24
Make a 90-degree bend at the mark made in the
last step. Temporarily connect the pushrod to the
throttle arm. Check the movement of the throttle to
verify there is no binding at either low or high
throttle. If there is, make the necessary adjustment
to eliminate any binding.

Section 15: Canopy Installation

Required Parts
• Fuselage assembly
Required Tools and Adhesives
• Canopy glue (RC-56)
• Sandpaper (medium grit)
Step 1
Install a pilot of your choosing. Use epoxy or
Zap-A-Dap-A-Goo to secure the pilot.
Step 2
Position the canopy onto the fuselage so the
front edge of the canopy is 3
instrument panel. Draw a line around the canopy
using a felt-tipped pen so 3/8" of the canopy will
overlap onto the fuselage.
34
• Canopy
7 / " forward of the
8
Step 25
Secure the throttle pushrod to the servo arm using
a nylon wire keeper. Install the throttle servo arm
screw when complete.
Photo for Step 2