Hangar 9 Twist 3D .40 Assembly Manual page 35

Step 3
Use a hobby knife and scissors to trim the canopy
along the lines drawn in the previous step.
Step 4
Position the canopy back onto the fuselage. Trace
around the canopy and onto the fuselage using
a felt-tipped pen.
Section 15: Canopy Installation
Step 5
Lightly sand the inside edge of the canopy and
slightly inside the line drawn on the hatch using
medium sandpaper.
Step 6
Apply a bead of RCZ56 Canopy Glue (ZINJ5007)
around the inside edge of the canopy. Position the
canopy onto the hatch. Use tape to hold it secure
until the glue fully cures.
35