Downloading The Firmware From The Usb Memory - Kyocera FS-9530DN Service Manual

(3) Downloading the firmware from the USB memory

The procedure below provides how to download firmware from a USB memory.
Procedure
1. Turn the main switch off.
2. Connect the USB memory to the PC.
Copy the firmware file to the root directory of
the USB memory.
3. Remove the USB memory from the PC and
then insert the USB memory into the
printer's USB memory slot.
4. Turn the main switch on.
5. When message display (1) is displayed to
detect firmware in the USB memory.
6. Message display (2) is displayed during
downloading.
7. When message display (3) is displayed to
indicate downloading is finished.
8. Turn the main switch off.
9. Remove the USB memory from USB mem-
ory slot.
10. Turn the main switch on.
11. Confirm that message display (4) is dis-
played after warm-up.
12. Print the status page. Print the status page
to check that the firmware version has been
updated.
USB memory
Figure 1-6-9
Main switch: On
Supervisor mode
(1)
Supervisor mode
(2)
USB data reading
2GZ_3000.001.021
(3)
05/10/27 [E1F9]
Main switch: Off
USB memory
Main switch: On
(4)
Ready
Figure 1-6-10
2GZ/2G1-1
USB
memory slot
Message display
Product code
2GZ: This machine
Firmware category
10: Engine controller
30: Main controller
Supplement
(Normally: 00)
Classification
(Normally: 0)
Update history
Build number
Release date:
Year/Month/Day
Checksum
USB
memory
slot
1-6-5