Kyocera FS-9530DN Service Manual page 122

2GZ/2G1-2
6. Remove two screws and two connectors,
and then remove the fan duct.
7. Remove six screws and remove the toner
container retainer.
8. Remove two pins and two spring. Remove
the screw and the connector, and then
remove the laser scanner unit.
9. Replace the laser scanner unit and install
the unit.
10. Refit the toner container retainer, fan duct
and inner cover.
11. Refit the top tray, front right cover and right
lower cover.
12. Refit the drum unit and the developing unit.
1-5-12
Connectors
Fan duct
Figure 1-5-27
Toner container retainer
Figure 1-5-28
Pin
Connector
Spring
Laser scanner unit
Figure 1-5-29
Pin
Spring
Screw