Table of Contents
Advertisement
FACTORY DEFAULT SETTINGS
The factory default configuration settings suffice for most applica-
tions. However, you can change these settings to create custom config-
urations using ISDN and User profiles (see Understanding Profiles on
page 3-6). You can also restore these settings at any time.
Restoring Factory Default Settings
To restore the Express 3100 to the factory default settings, follow the
steps below:
Instructions for Restoring Factory Default Settings
Step
1
Set DIP switch 2 to the OFF (Up) position.
2
Disconnect the Express 3100 from the power source.
3
Reconnect the power source for the Express 3100.
4
When the PWR LED flashes, set DIP switch 2 to the
ON (Down) position. (See also Setting the DIP Switches on
page 2-9)
USING ON-LINE HELP
The ADTRAN Express Configuration program includes on-line help.
You can access this help in two ways:
1.
Click on Help in the left panel of the ADTRAN Express Configu-
ration window.
OR
2.
From any dialog box, click the What's This? button ( ) in the
top, right-hand corner of the dialog box, and then click again
over the item in question.
61200240L2-20
Chapter 3. Using the Express Configuration Program
Action
Express 3100 User Manual
3-5
Advertisement
Table of Contents
