Table of Contents
Advertisement
CD-ROM or DVD-ROM drive
Drive considerations:
•
•
Complete the following steps to remove and install a CD-ROM or DVD-ROM drive in
your server:
1. Review the information in "Before you begin" on page 9 and "Safety Information"
2. Turn off the server and disconnect the power cords from the back of the server.
3. Push the CD-ROM or DVD-ROM eject button to the right.
4. Using the tab, pull the CD-ROM or DVD-ROM drive partially out of the server;
5. Install the new CD-ROM or DVD-ROM drive:
6. If you have other options to install or remove, do so now. Otherwise, connect the
26
xSeries 440:Option Installation Guide
Your xSeries 440 server supports the installation of up to two CD-ROM drives, or
two DVD-ROM drives.
If no other IDE drives are installed, the diskette drive must be installed in the right
external removable media bay. CD-ROM or DVD-ROM drives can be installed in
either external removable media bay.
on page 11.
Attention: The IDE drives installed in your server are not hot-swappable.
then, grasp the drive and remove it from the server.
a. Inspect the drive for any signs of damage.
b. Slide the CD-ROM or DVD-ROM drive into the drive bay until it stops.
External removable
media bays
CD-ROM
or DVD drive
power cords and turn on the server.
CD-ROM drive
eject button
Tab
Advertisement
Table of Contents
