Configuring Tcp/Ipv6 Network Settings - Canon ipf8300 User Manual

Network Setting
4.
Execute the following command to send the IP address to the printer and configure it.
ping [IP address as specified in the ARP command] -l 479
Example: ping xxx.xxx.xxx.xxx -l 479
Note
• The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and de-
fault gateway to match your network settings.
For details on RemoteUI, see "Using RemoteUI."

Configuring TCP/IPv6 Network Settings

When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.
Follow the steps below to configure the TCP/IPv6 network settings.
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
10
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select TCP/IP, and then press the OK button.
5.
Press ▲ or ▼ to select IPv6, and then press the OK button.
954
6.
Press ▲ or ▼ to select IPv6 Support, and then press the OK button.
7.
Press ▲ or ▼ to select On, and then press the OK button.
Configuring TCP/IPv6 Network Settings
Downloaded from ManualsPrinter.com Manuals
> Network Setting >
Note
• In -l, the l is the letter l.
• In Mac OS X when using Terminal, enter the ping command in the format
ping -s 479 xxx.xxx.xxx.xxx.
For details, refer to the help file for the command line.
Note
• If the Tab Selection screen is not displayed, press the Menu button.
→P.955
).
iPF8300