Reset Mode - Extron electronics XTP T USW 103 User Manual

Reset Mode

Use the recessed Reset button on the rear panel of the switcher to return the device to
default settings or to restore factory-shipped firmware.
POWER
12V
1.0 A MAX
Figure 11.
Mode Activation
Press the recessed Reset button
while applying power to the device.
NOTE: After a mode 1 reset,
update the device with the
latest firmware version. DO
NOT operate the system
with the firmware version that
results from this mode reset.
2
1
AUDIO
RGB HDMI
INPUTS
Rear Panel Reset Button
Reset Mode Summary
Result
The device reverts to the factory
default firmware.
NOTE: If you do not want to
update the firmware or perform
a mode 1 reset by mistake,
cycle power to the device to
return the firmware version
running prior to the reset.
OVER XTP
SIG LINK
3
RS-232
HDMI
XTP OUT LAN
Tx Rx G
Purpose/Notes
Use mode 1 to roll back
to factory firmware for a
single power cycle if an
incompatibility issue arises.
XTP T USW 103 Switcher • Operation
REMOTE
IR CONTACT RS-232
R
Tx Rx 1 2 3 G Tx Tx G
A
12