Using the XTP System Configuration Software
The XTP T USW 103 can be controlled directly from the front panel config port or remotely
from an XTP matrix switcher.
Connections
When opening the XTP System Configuration Software, the Connections screen opens
first. This screen is used to establish communication with an XTP device through a USB
connection (see
Figure 14.
1.
2.
3.
Config port
on page 10).
Connections Screen
From the Connections screen in the software, select the
figure 14,
).
1
From the displayed list, select the connected device to be controlled (see
Click the
button (see
Connect
XTP T USW 103 Switcher • XTP System Configuration Software
USB
). The Device Settings screen opens.
3
radio button (see
).
2
20