Btsi Output Circuit Shorted Or Open - Dodge Ram 2004 Service Manual

Symptom:

BTSI OUTPUT CIRCUIT SHORTED OR OPEN

When Monitored and Set Condition:
BTSI OUTPUT CIRCUIT SHORTED OR OPEN
When Monitored: With the ignition in the Unlock or On position and the operator's foot
applied to the brake pedal. (Customer Complaint: Vehicle can be shifted out of Park
without pressing the brake pedal.)
Set Condition: The Instrument Cluster detects a 0 or low value on the input circuit for
the BTSI when ON.
TCM DTC PRESENT
BTSI SOLENOID GROUND CIRCUIT OPEN
BTSI SOLENOID CONTROL CIRCUIT OPEN
BTSI SOLENOID CONTROL CIRCUIT SHORT TO BTSI SOLENOID GROUND CIRCUIT
BTSI SOLENOID CONTROL CIRCUIT SHORT TO GROUND
BTSI SOLENOID
INSTRUMENT CLUSTER
TEST
1 Turn the ignition on.
With the DRBIII , read DTCs.
Does the DRBIII display any TCM DTCs?
Yes → Refer to Transmission for the related symptom(s).
→ Go To 2
No
2 Turn the ignition off.
Disconnect the BTSI Solenoid harness connector.
Measure the resistance between ground and the BTSI Solenoid Ground circuit.
Is the resistance above 5.0 ohms?
Yes → Repair the BTSI Solenoid Ground circuit for an open.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
INSTRUMENT CLUSTER
429
APPLICABILITY
All
All