Dodge Ram 2004 Service Manual page 522

TELECOMMUNICATION
PCI BUS BUSY —
TEST
1 NOTE: For this code to be active, the DRBIII will not be able to communi-
cate with any modules on the vehicle (except the PCM).
NOTE: Clear the code. If this code continues to set and the DRBIII can still
communicate with the module, it will be necessary to replace the module.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, wiggle the wiring
harnesses. This is to try and duplicate the complete bus failure condition.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
Continued
ACTION
Perform BODY VERIFICATION TEST - VER 1.
508
APPLICABILITY
All