Dodge Ram 2004 Service Manual page 140

AIRBAG
PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND —
TEST
7 Disconnect the Airbag Control Module connector
NOTE: Check connectors - Clean and repair as necessary.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
Connect the appropriate Load Tool ACM Adaptor to the Airbag Control Module
connector(s).
Measure the resistance of the PAB Indicator Driver circuit between the ACM and the
PAB On - Off Switch connector.
Is the resistance below 5.0 ohms?
Yes → Go To 8
→ Repair the open Passenger Airbag Indicator Driver circuit.
No
8 Measure the resistance of the PAB Indicator Driver circuit between the PAB On - Off
Switch connector and ground.
Is the resistance below 10K ohms?
Yes → Repair the Passenger Airbag Indicator Driver circuit short to
→ Go To 9
No
9 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Reconnect the PAB Indicator connector.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.
Repair
ACTION
Perform __AIRBAG VERIFICATION TEST - VER 1.
ground.
Perform __AIRBAG VERIFICATION TEST - VER 1.
Replace the Airbag Control Module in accordance with Service
Instructions.
Perform __AIRBAG VERIFICATION TEST - VER 1.
126
Continued
APPLICABILITY
All
All
All