Fcm-Washer Pump Output Circuit Low - Dodge Ram 2004 Service Manual

WINDSHIELD WIPER & WASHER
Symptom:

FCM-WASHER PUMP OUTPUT CIRCUIT LOW

When Monitored and Set Condition:
FCM-WASHER PUMP OUTPUT CIRCUIT LOW
When Monitored: With the igntion on.
Set Condition: The FCM detects less than 0.05 volts on the Washer Pump Motor Control
circuit.
INTERMITTENT CONDITION
WASHER PUMP MOTOR - FRONT
WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO GROUND
POWER DISTRIBUTION CENTER
FRONT CONTROL MODULE
TEST
1 Turn the ignition on.
With the DRBIII , clear all FCM DTC's.
Actuate the Wiper Washers.
With the DRBIII , read the DTC information.
Does the DRBIII read: Washer Pump Output Circuit Low?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the Washer Pump Motor - Front harness connector.
Turn the ignition on.
With the DRBIII , read DTCs.
Does the DRBIII display: Washer Pump Output Circuit Open?
Yes → Replace the Washer Pump Motor - Front in accordance with the
→ Go To 3
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
532
APPLICABILITY
All
All