EXTERIOR LIGHTING
Symptom:
FCM-RIGHT LOWBEAM OUTPUT CIRCUIT LOW
INTERMITTENT CONDITION
RIGHT LOWBEAM OUTPUT CIRCUIT SHORT TO GROUND
FRONT CONTROL MODULE
POWER DISTRIBUTION CENTER
TEST
1
Turn the ignition on.
With the DRBIII , clear all FCM DTC's.
Actuate the Lowbeam headlamps.
With the DRBIII , read the DTC information.
Does the DRBIII read: Right Lowbeam Output Circuit Low?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2
Turn the ignition off.
Disconnect the IPM C7 harness connector.
Measure the resistance between ground and the Right Lowbeam Output circuit.
Is the resistance below 5.0 ohms?
Yes → Go To 3
→ Repair the Right Lowbeam Output circuit for a short to ground.
No
3
Turn the ignition off
Disconnect the FCM connector.
Disconnect the IPM C7 harness connector.
Measure the resistance between ground and the Right Lowbeam Output circuit in
the IPM.
Is the resistance below 5.0 ohms?
Yes → Replace the Power Distribution Center(PDC).
→ Replace the Front Control Module.
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
350
APPLICABILITY
All
All
All