Dodge Ram 2004 Service Manual page 566

VERIFICATION TESTS
Verification Tests —
1. Turn the ignition off.
2. Connect all previously disconnected components and connectors.
3. Ensure all accessories are turned off and the battery is fully charged.
4. Ensure that the Ignition is on, and with the DRBIII , erase all Diagnostic Trouble Codes
from ALL modules. Start the engine and allow it to run for 2 minutes and fully operate the
system that was malfunctioning.
5. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII, read
DTC's from ALL modules.
6. If any Diagnostic Trouble Codes are present, return to Symptom list and troubleshoot new
or recurring symptom.
7. If there are no DTC's present after turning ignition on, road test the vehicle for at least 5
minutes. Perform several antilock braking stops.
8. Caution: Ensure braking capability is available before road testing.
9. Again, with the DRBIII read DTC's. If any DTC's are present, return to Symptom list.
10. If there are no Diagnostic Trouble Codes (DTC's) present, and the customer's concern can
no longer be duplicated, the repair is complete.
Are any DTC's present or is the original concern still present?
Yes → Repair is not complete, refer to appropriate symptom.
→ Repair is complete.
No
1. Disconnect all jumper wires and reconnect all previously disconnected components and
connectors.
2. NOTE: If the SKIM, PCM or FCM was replaced, refer to the service information for
proper programming procedures.
3. If the Instrument Cluster was replaced, disconnect the negative battery cable for 5 seconds
to power down FCM then reconnect and turn the ignition on for 15 seconds to learn VIN.
4. If the Instrument Cluster was replaced and the vehicle is equipped with VTSS, cycle the key
in the driver door cylinder lock switch to enable VTSS.
5. Program tire size, country code, radio EQ setting and all RKE transmitters (if RKE Module
was replaced) and other options as necessary.
6. If any HVAC door actuator circuits were repaired, with the DRBIII in HVAC, System Tests,
select Actuator Circuit Test.
7. If any HVAC door actuators were replaced/door linkage was repaired, with the DRBIII in
HVAC, System Tests, select HVAC Door Recalibration.
8. Ensure all accessories are turned off and the battery is fully charged.
9. With the DRBIII , record and erase all DTC's from ALL modules. Start and run the engine
for 2 minutes. Operate all functions of the system that caused the original concern.
10. Turn the ignition off and wait 5 seconds. Turn the ignition on and using the DRBIII , read
DTC's from ALL modules.
Are any DTC's present or is the original condition still present?
Yes → Repair is not complete, refer to the appropriate symptom.
→ Repair is complete.
No
Continued
ABS VERIFICATION TEST - VER 1
BODY VERIFICATION TEST - VER 1
552
APPLICABILITY
All
APPLICABILITY
All