Dodge Ram 2004 Service Manual page 531

RIGHT AUDIO INPUT SHORT TO GROUND —
TEST
6 Turn the ignition off.
Disconnect the Radio C2 harness connector.
Disconnect the Hands Free Module harness connector.
Measure the resistance between the Left Audio Output circuit and the Right Audio
Output circuit.
Is the resistance above 1000 ohms?
Yes → Inspect the wiring and connectors for damage or shorted circuits.
→ Repair the Left Audio Output circuit for a short to the Right Audio
No
7 NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, wiggle the wiring
harnesses. This is to try and duplicate the failure.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Repair as necessary. If ok, replace and program the Hands Free
Module in accordance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
Output circuit.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
TELECOMMUNICATION
Continued
517
APPLICABILITY
All
All