FCM-WASHER FLUID LEVEL SENSOR CIRCUIT FAILURE —
TEST
4
Turn the ignition off.
Disconnect the FCM harness connector.
Disconnect the Washer Fluid Level Switch harness connector.
Measure the resistance between ground and the Washer Fluid Level Switch Signal
circuit.
Is the resistance below 5.0 ohms?
Yes → Repair the Washer Fluid Level Switch Signal circuit for a short to
→ Replace the Front Control Module (FCM) in accordance with the
No
ACTION
ground.
Perform BODY VERIFICATION TEST - VER 1.
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
WINDSHIELD WIPER & WASHER
531
Continued
APPLICABILITY
All