Dodge Ram 2004 Service Manual page 37

INTERNAL MODULE TEST —
OUTPUT DRIVER 1
When Monitored: With the ignition on, the module on board diagnostics continuously
performs internal circuit tests.
Set Condition: This DTC will set if the module identifies an out of range internal circuit.
STORED ENERGY FIRING 1
When Monitored: With the ignition on, the module on board diagnostics continuously
performs internal circuit tests.
Set Condition: This DTC will set if the module identifies an out of range internal circuit.
AIRBAG CONTROL MODULE - ACM
TEST
1 Turn the ignition on.
NOTE: Ensure the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
Select the appropriate module and DTC type combination:
ACM - ACTIVE DTC
ACM - STORED DTC
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.
Repair:
Continued
POSSIBLE CAUSES
ACTION
Go To 2
Go To 2
Replace the Airbag Control Module in accordance with Service
Instructions.
Perform __AIRBAG VERIFICATION TEST - VER 1.
23
AIRBAG
APPLICABILITY
All
All