Fcm-Right Lowbeam Output Circuit Open - Dodge Ram 2004 Service Manual

Symptom:

FCM-RIGHT LOWBEAM OUTPUT CIRCUIT OPEN

INTERMITTENT CONDITION
RIGHT LOWBEAM OUTPUT CIRCUIT OPEN
FRONT CONTROL MODULE
POWER DISTRIBUTION CENTER
TEST
1 Turn the ignition on.
With the DRBIII , clear all FCM DTC's.
Actuate the Lowbeam headlamps.
With the DRBIII , read the DTC information.
Does the DRBIII read: Right Lowbeam Output Circuit Open?
Yes → Go To 2
→ The condition that caused the symptom is currently not present.
No
2 Turn the ignition off.
Disconnect the IPM C7 harness connector
Measure the resistance of the Right Lowbeam Output circuit.
Is the resistance above 5.0 ohms?
Yes → Repair the Right Lowbeam Output circuit for an open.
→ Go To 3
No
3 Turn the ignition off
Disconnect the FCM from the IPM.
Disconnect the IPM C7 harness connector.
Measure the resistance of the Right Lowbeam Output circuit.
Is the resistance above 5.0 ohms?
Yes → Replace the Power Distribution Center..
→ Replace the Front Control Module.
No
POSSIBLE CAUSES
ACTION
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
EXTERIOR LIGHTING
351
APPLICABILITY
All
All
All