TRANSMISSION
TRANSMISSION ASSEMBLY
Clean all parts in solvent.
Apply molybdenum oil solution to the gear and bushing
sliding surface and shift fork grooves to ensure initital
lu-
brication.
Assemble all parts into their original positions.
NOTE:
*
Check the gears for freedom of movement or rotation
pn the shaft.
Install the washers and snap rings with the chamfered
edges facing the thrust load side. Do not reuse worn
snap ring which could easily spin in the groove.
Check that the snap rings are seated in the grooves and
align their end gaps with the grooves of the spline.
CORRECT
INCORRECT
SNAP RING
MAINSHAFT
M6 GEAR (26T)
THRUST WASHER
\
SPLINE WASHER
SPLINE WASHER
M3/4 GEAR (20/22T)
WASHER AND SNAP RING DIRECTION:
:
Gear and bushing sliding
surfaces and
12-10