Exerpeutic 1112 Owner's Manual page 17

ASSEMBLY
5
Tool:
18 18
19 19
12 12
11 11
10 10
4
Allen Wrench 5mm
13 13
9
6
13 13
4
6
3
29 29
17 17
2
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
8. Left/Right Handrails and Backrest Installation
Use 5mm Allen Wrench to remove four Big Washers (18) and four Bolts (19) from the
Backrest (5).
Align and hold the Backrest (5) onto the Back and Seat Support Bracket (17), use 5mm
Allen Wrench to tighten four Big Washers (18) and four Bolts (19) until firm and secure.
Use the Multi Hex Tool with Phillips Screwdriver to remove four Bolts (2) and four Washers
(3) from the Back and Seat Support Bracket (17).
Align and hold the Left Handrail (4) onto the Back and Seat Support Bracket (17), use the
Multi Hex Tool with Phillips Screwdriver to tighten four Bolts (2) and four Washers (3) until
firm and secure.
Connect the Hand Pulse Sensor Wire (6) from the Left Handrail (4) to the Extension Hand
Pulse Sensor Wire (13) from the Right Handrail (12).
Insert the Right Handrail (12) into the tube hole of the Left Handrail (4) and secure with two
Bolts (9), two Big Curve Washer (10), and two Cap Nuts (11). Tighten cap nuts with Multi
Hex Tool with Phillips Screwdriver provided.
Connect the Extension Hand Pulse Sensor Wire I (29) to the Hand Pulse Sensor Wire (6)
and Extension Hand Pulse Sensor Wire (13).
Hardware:
(#9) Bolt (#10) Big Curve Washer (#11) Cap Nut
2 PCS 2 PCS 2 PCS
16