Table of Contents
Advertisement
Installing and Setting up the Machine > Default Settings of the Machine
Default Settings of the Machine
Before using this machine, configure such settings as date and time, network configuration, and energy saving functions
as needed.
NOTE
The default settings of the machine can be changed in System Menu. For settings that are configurable from System
Menu, refer to
Setup and Registration (System Menu) (page
Setting Date and Time
Follow the steps below to set the local date and time at the place of installation.
When you send an E-mail using the transmission function, the date and time as set here will be printed in the header of
the E-mail message. Set the date, time and time difference from GMT of the region where the machine is used.
NOTE
• If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and press [Login].
The factory default login user name and login password are set as shown below.
4000
• Be sure to set the time difference before setting the date and time.
1
Login User Name
Display the screen.
1
Press the
[System
Menu/Counter] key.
2
Press the [▲] or [▼] key to select [Common Settings], and press the [OK] key.
Sys. Menu/Count.:
04
User/Job Account
User Property
05
Common Settings
06
Exit
3
Press the [▲] or [▼] key to select [Date Setting], and press the [OK] key.
Common Settings:
Measurement
07
08
Error Handling
Date Setting
09
Exit
8-1).
Login Password
4000
1
1
2-11
2
2
Advertisement
Table of Contents
Troubleshooting
