SERVICE WORK ON THE CHASSIS
Removing the seat
10.22
Mounting the seat
10.23
Removing the air filter box lid
10.24
–
Position the exhaust manifold.
–
Attach springs
Spring hooks (50305017000)
–
Mount and tighten screw
Guideline
Remaining screws, chassis
100916-11
–
Position the angle lever and linkage lever.
–
Mount and tighten screw cap
Guideline
Nut, linkage lever to angle lever
–
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
100914-11
–
Install the main silencer. (
–
Remove the motorcycle from the lift stand. (
–
Remove screw
–
Lift up the seat at the rear, pull it back and then remove it from above.
B00317-10
–
Hook in the front of the seat at the collar bushing of the fuel tank, lower it at the
rear and simultaneously it push forward.
–
Make sure that the seat is correctly locked in.
–
Mount and tighten the screw of the seat fixation.
Guideline
Remaining screws, chassis
B00318-01
–
Pull off the air filter box lid in area
100919-10
.
.
M8
.
M14x1.5
.
M10
p. 42)
.
M6
sideways and remove it toward the front.
25 Nm
(18.4 lbf ft)
80 Nm (59 lbf ft)
60 Nm
Loctite
®
2701
(44.3 lbf ft)
p. 32)
10 Nm (7.4 lbf ft)
40