11.20
Removing the seat
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
–
Position left frame protector.
–
Insert right frame protector from below and push to the rear.
–
Mount and tighten screws
Guideline
Screw, frame protec-
tor
–
Mount and tighten screw
Guideline
F01527-11
Screw, frame protec-
tor
–
Mount the new cable ties.
Finishing work
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
–
Remove screw
F01533-10
–
Raise the rear of the seat, pull the seat back, and lift it off.
H02218-10
SERVICE WORK ON THE CHASSIS 11
8
with the washers.
M5
3 Nm (2.2 lbf ft)
9
.
M5
3 Nm (2.2 lbf ft)
1
.
p. 88)
p. 50)
63