Alert Notification Window - Cisco Video Surveillance 3000 Series Configuration Manual

Alert Notification Window

HTTP notification—IP camera sends notification to a remote system via HTTP. This information
•
includes the following:
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
FTP notification—An event can cause the IP camera to upload a video clip or a snapshot of the
•
activity that triggered the event to an FTP server.
The Event Notification window also allows you to designate schedules. If an event takes place within a
designated schedule, the IP camera takes the actions that you configure.
Procedure
Step 1 From the IP camera user interface, click the Setup link.
Click Feature Setup to expand the menu.
Step 2
From the Feature Setup menu, click Alert.
Step 3
The Alert Notification window appears. If you change any options in this window, you must click the
Save button to save the changes. If you do not click this button, changes are not retained when you exit
the window. The Save button appears at the bottom of the window. You may need to scroll down to it.
Table 4-8
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
4-24
Device ID—ID of the IP camera.
Device name—Name of the IP camera.
IP address—IP address of the IP camera.
MAC address—MAC address of the IP camera.
Channel ID—Channel identification number (1 for primary stream or 2 for secondary stream).
Channel name—Name that is configured for the channel.
Date and time—Date and time that the event occurred.
Active post Count—Sequence number of the notification for this event.
Event type—Type of event.
Event state—Indicates whether the event is active or inactive at the time that the event was
detected for this notification.
Event description—Description of the event.
Input port ID—If the event was triggered by an input port state change, port ID of the port
Region index—If the event was triggered by motion detection, identification number of the
region in which the IP camera detected motion.
Sensitivity level—If the event was triggered by motion detection, sensitivity that is configured
for the region in which motion was detected.
Detection threshold—If the event was triggered by motion detection, threshold that is
configured for the region in which motion was detected.
describes the options in the Alert Notification window.
Chapter 4 Feature Setup
OL-32285-01