Cisco Video Surveillance 3000 Series Configuration Manual page 72

App Setup Window
Table 6-3
Option
Installed Application List Area
Application list
Run button
Stop button
Configure button
Uninstall button
Maintenance Area
Restore button
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
6-4
App License Window Options (continued)
Description
Provides this information for each app that is installed on the IP camera:
Select—Click the radio button that corresponds to an app to start, stop,
•
configure, or uninstall the app
Application—Name of the app
•
Version—Version of the app
•
Vendor—Provider of the app
•
Status—Operating status of the app (Running or Stopped)
•
Start on Boot?—To cause an app to run automatically each time the IP
•
camera restarts, click the radio button for the app, check this check box,
and then click Run
Installed On—Date and time that the app was installed on the IP camera
•
Started On—Date and time that a running app was last started
•
Package Detail—Name of the app package that was installed
•
To run an app, click the radio button in the Select column that corresponds
to the app, then click Run.
Depending on the complexity of an app, you may be able to run multiple
apps simultaneously on an IP camera, but you cannot run two audio apps or
two video apps at the same time.
To stop an app that is running, click the radio button in the Select column
that corresponds to the app, click Stop, and then click OK in the
confirmation dialog box.
To configure an app, click the radio button in the Select column that
corresponds to the app, then click Configure.
The configuration window for the app appears. The options in this window
depend on the app. For detailed information, see Cisco IP Camera Apps
Reference Guide.
If you configure an app that is running, you must stop and then restart the
app before the changes take effect.
To permanently remove an app from the IP camera, click the radio button in
the Select column that corresponds to the app, Uninstall, and then click OK
in the confirmation dialog box.
You must stop a running app before you can uninstall it.
Click this button to reset all app manager settings to their factory default
values and permanently remove all apps from the IP camera.
This button should be used only if the IP camera becomes unstable after an
app is installed or run.
Chapter 6 Application Manager
OL-32285-01