Installing an App on an IP Camera
Uninstalling an App
To uninstall an app from an IP camera, perform the following steps.
If the app is running, you must first stop it as described in the
Procedure
Step 1
From the IP camera user interface, click the Setup link, click Application Manager to expend the menu,
then click App Setup.
Step 2
Click the radio button for the app that you want to uninstall.
Step 3
Click the Uninstall button.
Click OK in the confirmation window that appears.
Step 4
If you do not want to uninstall the app , click Cancel.
Restoring the Application Manager
When you restore the application manager to the factory default condition, all apps that you uploaded to
the IP camera are removed from the camera.
This feature should be used only if the IP camera becomes unstable after an app is installed or run.
To restore the application manager on an IP camera, follow these steps:
Procedure
From the IP camera user interface, click the Setup link, click Application Manager to expend the menu,
Step 1
then click App Setup.
Click the Restore button in the Maintenance area.
Step 2
Click OK in the confirmation window that appears.
Step 3
If you do not want to restore the application manager, click Cancel.
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
6-8
Chapter 6
Application Manager
"Stopping an App" section on page
6-7.
OL-32285-01