Setup Windows; Basic Setup Window - Cisco CIVS-IPC-2500 User Manual

Chapter 3 Configuring and Managing the IP Camera
•

Setup Windows

The Setup windows let you configure a variety of basic and advanced settings for the IP camera, and to
designate IP addresses that are allowed or denied access to the IP camera.
The following sections describe the Setup windows in detail:
•
•
•

Basic Setup Window

The Basic Setup window provides options for configuring device and network settings for the IP camera.
To display the Basic Setup window, access the configuration windows as described in the
the Initial Setup of the IP Camera" section on page
If you change any options except the Current Date/Time in the Basic Setup window, you must click Save
to save the changes. To discard the changes, click Cancel before clicking Save. These buttons appear at
the bottom of the window. You may need to scroll down to see them.
Table 3-2
Table 3-2
Option
Device Settings
Device ID
Camera Name
Description
OL-14220-01
Status
System
–
Audio Video
–
Network
–
Syslog & Log
–
– Video Log
Basic Setup Window, page
Advanced Setup Window, page
IP Filter Window, page 3-9.
describes the options in the Basic Setup window.
Basic Setup Window Options
Description
Display only. Unique identifier of the IP camera. The device ID is configured
for the IP camera at the factory.
Enter a name for the IP camera. This name appears in the video log if an
event occurs. (For related information, see the
on page
The camera name can include any combination of up to 15 letters and
numbers. Cisco recommends that you give each IP camera a unique name so
that you can identify it easily.
Enter a description of the IP camera. For example, enter the IP camera
location, such as "North Entrance."
The description can include any combination of up to 32 letters, numbers,
and spaces.
3-5.
3-7.
2-4, click Setup, then click Basic Setup.
3-37.)
Cisco Video Surveillance System IP Camera User Guide

Setup Windows

"Performing
"Video Log Window" section
3-5