Table of Contents
Advertisement
Chapter 7
Administration
Procedure
Step 1
From the IP camera user interface, click the Setup link.
Step 2
Click Administration to expand the menu.
Step 3
From the Administration menu, click Maintenance.
The Maintenance window appears.
Table 7-3
Table 7-3
Option
Factory Default Area
Restore button
Reset button
Reboot Area
Reboot button
OL-32285-01
describes the options in the Maintenance window.
Maintenance Window Options
Description
Click the Restore button to reset all IP camera settings to their factory
default values.
To confirm the restore procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.
This action has the same effect as pressing and holding the Reset button on
the IP camera for at least 15 seconds. After you perform this procedure,
follow the steps in the
Camera."
Click the Reset button to reset all IP camera settings except the static IP
address, gateway IP address, and log in credentials (user name and
password) to their factory default values.
To confirm the restore procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.
Click the Reboot button to reboot the software on IP camera.
To confirm the reboot procedure, click OK in the confirmation pop-up
window. Otherwise, click Cancel.
This action has the same effect as pressing and immediately releasing the
Reset button on the IP camera, or powering the IP camera down and then
powering it up.
Chapter 2, "Performing the Initial Setup of the IP
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
Maintenance Window
7-5
Advertisement
Table of Contents
