Ip Filter Window - Cisco Video Surveillance 3000 Series Configuration Manual

IP Filter Window

Table 5-7
Option
Password
Anonymous ID
IP Filter Window
The IP Filter window provides options for controlling access to the IP camera by designating up to 10
IP addresses or address ranges that are allowed or denied access to the IP camera.
To display the IP Filter window, perform the following steps:
Procedure
From the IP camera user interface, click the Setup link.
Step 1
Click Network Setup to expand the menu.
Step 2
From the Network Setup menu, click IP Filtering.
Step 3
The IP Filter window appears. If you change any options in this window, you must click the Save button
to save the changes. If you do not click this button, changes are not retained when you exit the window.
The Save button appears at the bottom of the window. You might need to scroll down to it.
Table 5-8
Table 5-8
Option
IP Filter Area
Enable IP Filtering
Filter Entries Area
#
Action
IP Address/Bit Mask
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
5-12
802.1x Window Options (continued)
Description
Enter the password that the IP camera uses to access the RADIUS server.
Optional. Anonymous identifier to be used instead of a user name for
logging in to the RADIUS server.
describes the options in the IP Filter window.
IP Filter Window Options
Description
Check this check box to cause the IP camera to allow or deny access to IP
addresses as configured in the IP Filtering window.
Display only. Filter number.
Choose an action for the corresponding IP address or address range:
Deny—IP address or address range cannot access the IP camera.
•
Allow—IP address or address range can access the IP camera.
•
Enter the IP address and bit mask to which the corresponding action applies.
Make these entries in Classless Inter-Domain Routing (CIDR) notation.
CIDR is defined in RFC 4632.
Chapter 5 Network Setup
OL-32285-01