Table of Contents
Advertisement
Local Log Window
Table 8-3
Log Messages
Message Name
CODEC_LOST
CONFIG_SAVE_FAILED
CONFIG_SAVED
CONFIG_UPLOAD_FAILED
CONFIG_UPLOADED
DEFAULTS_FAILED
DEFAULTS_RESTORED
DEVICE_REBOOT_AUTO
DEVICE_REBOOT_MANUAL
DHCP_LEASE
DSP_ENCODING_HALTED
EMAIL_TRIGGERED
ETH_BER
ETH_SIGNAL_DEGRADE
FRAMES_DROPPED
FW_UPGRADE_FAILED
FW_UPGRADED
HTTP_TRIGGERED
Cisco Video Surveillance 3000 Series IP Camera Configuration Guide
8-6
Description that Appears in Log File
Connection to Codec/Sensor module
was lost. Internal module is either down
or not responding.
Saving configuration to user <user>
<IP address or hostname> failed.
Configuration saved by user <user>
<IP address or hostname>.
Uploading configuration failed from
user <user> <IP address or hostname>.
Configuration uploaded from user
<user> <IP address or hostname>.
Restoring factory defaults failed for
user <user> <IP address or hostname>.
Factory defaults restored successfully
by user <user> <IP address or
hostname>.
Device rebooted.
Device was rebooted manually by user
<user> <IP address or hostname>.
DHCP lease renewal was successful.
The Codec/Sensor module's DSP
encoding was halted. Either the analog
image signal from the sensor has been
lost, or an internal encoding error has
occurred.
Event triggered: email sent to <e-mail
address>.
Bit Error Rate (BER) exceeded
specified threshold of <threshold>.
Ethernet signal degrading.
Output frame rate does not match the
camera's configured frame rate.
Upgrading firmware failed from user
<user> <IP address or hostname>.
Firmware upgraded successfully from
user <user> <IP address or hostname>.
Event triggered: notification sent to
HTTP server <IP address or
hostname>.
Chapter 8
Explanation
The IP camera codec/sensor module is
not responding.
A user attempt to save the IP camera
configuration failed.
The IP camera configuration was saved
by a user.
A user attempt to import the IP camera
configuration failed.
The IP camera configuration was
imported by a user.
An attempt to reset the IP camera to its
factory default configuration failed.
The IP camera was reset to its factory
default configuration.
The IP camera rebooted automatically. 5
The IP camera was rebooted by a user. 5
The IP camera renewed its DHCP
lease.
The DSP of the IP camera codec/sensor
module DSP stopped encoding. The
analog image signal from the sensor
may be lost or an internal encoding
error may have occurred.
An event occurred and e-mail
notification of the event was sent.
The bit error rate (BER) exceeded the
specified threshold.
The IP camera detected a degrading
Ethernet signal.
The IP camera is sending video at a
frame rate that does not match the
configured frame rate.
An attempt to upgrade the IP camera
firmware failed.
The IP camera firmware was updated.
An event occurred, and HTTP
notification of the event was sent.
Log Configuration
Severity
4
3
5
3
5
3
5
6
2
5
4
4
3
0
5
5
OL-32285-01
Advertisement
Table of Contents
