Sp Motor Asy - Epson DFX-9000 Service Manual

Epson DFX 9000

4.2.4.4 SP MOTOR ASY

Do not touch the SP MOTOR ASY immediately after
W A R N I N G
using the printer, or you may burn your hand. Allow the
motor assembly to cool enough to work with it.
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Disconnect the SP MOTOR ASY cable from the connectors on the
ROM BOARD (CNSPM: 3 pins, CNSPHS: 7 pins). See
4. Release the SP MOTOR ASY cable from the cable clamp on the
bottom rear of the printer, and pull the cable out through the hole in
the SIDE FRAME, RIGHT.
5. Remove the two C.B.S. 3 × 6 screws that secure the FAN3 MOTOR,
and remove it.
6. Remove the two C.B.S. 3 × 8 screws that secure the Stopper BR to
the SIDE FRAME, RIGHT, and remove the Stopper BR.
CNSPHS
Figure 4-31. SP MOTOR ASY connectors on the ROM BOARD
Disassembly and Assembly
Figure 4-31.
CNSPM
7. Remove the three C.P. (S-P1) 4 × 10 screws that secure the SP
MOTOR ASY to the bracket of the SIDE FRAME, RIGHT.
SP MOTOR ASY
SP MOTOR ASY
Figure 4-32. SP MOTOR ASY Removal (1)
6)
Stopper BR
Figure 4-33. SP MOTOR ASY Removal (2)
Revision B
5)
FAN3 MOTOR
5)
156