Epson DFX-9000 Service Manual page 247

Epson DFX 9000
6. From the Adjustment Program, execute the
.
Detection Adjustment
Figure 5-22. APTC Thickness Detection Adjustment screen
7. Click
Enter adjustment mode
thickness value on the printer's Operation Panel LCD.
A P G C o u n t W r i t e
1 P = X X X X
8. Press the [Pause] button on the Operation Panel to register the new
paper thickness value for a single sheet of paper.
9. Turn OFF the printer.
After registering the adjustment value by pressing the
C A U T I O N
[Pause] button, be sure to turn OFF the printer.
The value is only stored in EEPROM at power OFF.
Adjustment
APTC Thickness
, and check the displayed paper
Software adjustment
10. Turn ON the printer.
11. Press the [LF/FF] button on Operation Panel to eject the paper.
12. Set 10 sheets of stacked or folded 50 g/m
tractor, and press the [Load] button on the Operation Panel to load
the paper into the mechanism.
13. Click
Enter adjustment mode
thickness value on the printer's Operation Panel LCD.
14. Press the [Pause] button on the panel to register the new paper
thickness value for 10 sheets of paper.
15. Turn the printer OFF.
16. Turn the printer ON again, and press the [LF/FF] button to eject the
paper.
17. Turn the printer OFF.
18. Remove the jigs from the printer.
Revision B
2 (13 lb) paper on the front
, and check the displayed paper
240