Epson DFX-9000 Service Manual page 169

Epson DFX 9000
4.2.4.8 LF BELT
1. Remove the UPPER UNIT (p. 135)
2. Tilt up the rear of the PR MECHA ASY and support it using the tilt
bar. Refer to section 4.2.4.1 PR MECHA ASY, p. 149.
3. Loosen the screw that secures the Tension pulley unit to the SIDE
FRAME, LEFT. Slide the Tension pulley unit in the direction of the
arrow (downward) to release the tension of the LF BELT, and then
remove the LF BELT.
When installing the Tension pulley unit, match the
positioning hole of the Tension pulley unit with the dowel.
Be sure to perform the
A D J U S T M E N T
R E Q U I R E D
(p. 222) after removing or replacing the LF BELT.
Disassembly and Assembly
LF drive belt tension adjustment
Tension pulley unit
Dowel
Figure 4-41. LF BELT Removal
LF BELT
Revision B
LF BELT
3)-2
3)-1
3)-3
162