Epson DFX-9000 Service Manual page 199

Epson DFX 9000
9. Hold both the SS bearing on the left end of the Stay shaft and the
bearing on the right end, and slowly pull out the Stay shaft to the left
rotating it until the right end of the Stay shaft nearly reaches the
CARRIER UNIT.
When pulling and rotating the Stay shaft, be careful not to
C A U T I O N
damage the Stay shaft with the sharp edge of the hole (the
through-hole for the Stay shaft) in the SIDE FRAME,
LEFT.
10. Remove the bearing and washer on the right end of the Stay shaft,
and then slowly pull the Stay shaft out from both the CARRIER
UNIT and the SIDE FRAME, LEFT.
The Stay shaft should be touched as little as possible.
C A U T I O N
When inserting the Stay shaft, be careful not to damage
the surface of the Stay shaft with the hole of the SIDE
FRAME, LEFT.
Disassembly and Assembly
Stay shaft
Handling point
Stay shaft
Caution
Figure 4-76. Stay shaft Removal (3)
CARRIER UNIT
Handling point
SP washer
CARRIER UNIT
Be careful not to
scratch the Stay shaft
against the frame hole.
Revision B
Bearing
192