Epson DFX-9000 Service Manual page 243

Epson DFX 9000
3. Click
Enter adjustment mode
Mode, and verify that:
The CARRIER UNIT is at the Ribbon cartridge replacement
position. (See Figure 5-18).
The Platen Gap is at the widest position once the mechanical
initialization has completed.
Ribbon cartridge replacement position
Figure 5-18. Mechanical Position Check
Adjustment
to enter the TOF Sensor Adjust
PG Widest
Position
Software adjustment
4. Locate the two variable resistor (VR) signal adjustment screws on
the CARRIER UNIT. See Figure
Figure 5-19. Location of TOF Signal Adjustment Screws
5. For each variable resistor adjustment screw: First turn it counter-
clockwise until it stops. The corresponding LED (See
not lit. Slowly turn the screw clockwise until the LED lights and
stays on.
Revision B
5-19.
TOF (L) TOF (R)
Figure 5-19) is
236