Epson DFX-9000 Service Manual page 24

Epson DFX-9000
1.2.6.3 Labels
Labels and labeled forms must be plain paper or equivalent quality.
Table 1-11. Label specifications, front or rear paper path
Item Min.
Label size Refer to Figures 1-10 and 1-11
Base sheet width mm 76.2
inch 3
Base sheet length mm 76.2
(one page)
inch 3
Base sheet mm 0.07
thickness
inch 0.0028
Total thickness mm 0.16
inch 0.0063
2
Label weight g/m 64
lb 17
Notes: 1. Printing on labels must only be done under normal
temperature and humidity conditions.
2. The base sheet must be continuous paper.
3. Do not reverse-feed or pull label sheets backward through the
printer.
4. Eject the label sheets before you turn off the printer.
5. Don't print on the base sheet.
6. It is recommended that you use labels with base sheets
entirely covered with label material.
Product Description
Max.
Labels and base sheet type
419.1
16.5
558.8
22
0.09
0.0035
0.19
0.0075
Basic specifications
7. When printing on labels with base sheets not completely
covered with label material, make sure the paper thickness
(platen gap) is measured on the label, or use the appropriate
manual setting.
8. Do not print labels when the Perforation Cutter is installed.
Base Sheet Label Sheet
Figure 1-10. Base sheets entirely covered with label material
Base Sheet Label
Figure 1-11. Base sheets not covered with label material
Revision B
Several uncut
areas on each side
Label of label
Each corner of the label
is uncut
Label
More than
63.5 mm
(2.5 inch)
Corner radius
is more than
R2.5 mm
(0.1inch)
17