Epson DFX-9000 Service Manual page 196

Epson DFX 9000
4.2.4.16 CARRIER CABLE UNIT
Do not touch the motors or the PRINT HEAD immediately
W A R N I N G
after using the printer, or you may burn your hand. Allow
them to cool enough to work with them.
A ferrite core is attached to the CARRIER CABLE UNIT
C A U T I O N
to prevent electromagnetic interference. Handle the
CARRIER CABLE UNIT with care when removing or
installing it.
1. Remove the PR MECHA ASY (p.
2. Release the cables from the two cable clamps on the SIDE FRAME,
RIGHT.
3. Remove the C.B.S. 3 × 6 screw that secures the CR cable cover, and
remove the CR cable cover.
4. Release the six tabs that secure the Cable cover to the frame, and
remove the Cable cover.
5. Slide the Cable holder to the left, as shown by the arrow in Figure
4-71, and remove it.
Disassembly and Assembly
149).
CARRIER CABLE UNIT
Cable clamp
CARRIER CABLE UNIT
6 Tabs
4)
Cable cover
5)
Figure 4-71. CARRIER CABLE UNIT Removal (1)
Revision B
3)-1
Cable clamp
3)-2
CR cable cover
Cable holder
CARRIER CABLE UNIT
189