Adjustment - Epson DFX-9000 Service Manual

Epson DFX 9000
4.2.4.5 SP BELT
The Carrier PCB and a ferrite core is attached are attached
C A U T I O N
to the CARRIER UNIT. Handle them with care when
removing or replacing the SP BELT.
1. Remove the SP MOTOR ASY (p. 156)
2. Remove the two C.B.S. 3 × 6 screws that secure the BELT clamp
that fastens the SP BELT to the CARRIER UNIT, and remove the
SP BELT.
When removing or installing the SP BELT, be careful
C A U T I O N
not to damage the CES SCALE.
When installing the SP BELT, be careful not to
separate the CES SCALE from the CES sensor.
Be sure to perform the
A D J U S T M E N T
R E Q U I R E D
adjustment (p. 220)
BELT.
Disassembly and Assembly
CR drive belt (SP BELT) tension
after removing or replacing the SP
CARRIER CABLE UNIT
CES sensor
BELT clamp
Figure 4-36. SP BELT Removal
SP BELT
Revision B
CARRIER UNIT
2)-1
SP BELT
2)-2
158