Kantronics KPC–3 Plus User Manual page 83

Reading Messages
To read a message (e.g., a bulletin such as that in the previous section listed as being
to ALL), use the READ command (see PBBS command section for details on using this
command).
Editing Message Headers
The following command can be used to edit message headers:
E(dit) n [BPTYNFH] [>tocall] [<fromcall] [@BBS] "old" "new"
This command, available only to the system operator (SYSOP), or to a user at the
keyboard, allows the sysop to edit the message headers listed below for any message
in the mailbox. You are the sysop if you can connect to the PBBS from the RS232 port.
You can also gain sysop status by connecting to the PBBS remotely (by radio); see the
section titled ―Remote Sysop Access to your PBBS‖ for more detail.
You can change:
The TYPE of the message:
The STATUS of the message:
Who the message is to or from:
The destination mailbox (@BBS):
B — Bulletin
P — Private
T — Traffic
Y — Yes [it has been read]
N — No [it has not been read]
F — Forwarded [it has been forwarded]
H — Held [it is not available for reverse forwarding]
Note: F and H are toggles. Entering F switches the status of the
message from F to NOTF or from NOTF to F. Similarly, entering H
switches the status of the message from H to NOT H or from NOT H to
H.
>tocall
<fromcall
@BBS[.haddr]
83